• How to restring your classical guitar

    How do I restring my classical guitar?

    Has your classical guitar started to slip out of tune more quickly? Or maybe the tone isn’t as bright and alive as it was a few months ago? …and perhaps the fretboard isn’t looking as clean as it should…
    These are all signs that it’s time to restring your guitar! Our Take it away music shop member Forsyth has put together a step-by-step process on how to do it yourself.
    They say: “Restringing a nylon-strung guitar is a little fiddlier than a steel-strung acoustic but it’s still an easy skill to learn. In this post, we’ll cover how to approach changing the strings on a traditional classical guitar.”
    Remember, practice makes perfect!
    1. Firstly, we need to get the old strings off. Depending on how they were put on previously this can take a few minutes!
    Loosen the tuning pegs until the strings become free.

    Undoing pegs on neck of guitar

    2. It’s a lot easier at this end! They should be easy to pull loose once the tension is taken off:

    untying guitar strings at base of guitar

    3. Ok, time to tie some knots! First, pass the end of the high E string through the hole in the bridge heading away from the neck so that the string end pokes out of the back of the bridge.
    The length of string behind my thumb and forefinger is the long part that we’re going to tie on at the other end:

    Tying a new E string at base of guitar

    4. Now we’re going to bring the end of the string back on itself.
    Notice that the end of the string goes to the treble side of the long length of string (or behind the long string if you’re looking at the guitar as in the photos:

    tying new guitar string at base of guitar

    5. And round it goes to make a loop passing around the long length of the string:

    tying new E string on classical guitar

    6. Now we’re going to wrap a couple of turns of the end of the string around on itself. Over the top and underneath:

    tying knot

    7. And again…

    tying knot on guitar string

    8. Lastly we just need to pull the knot tight and it will lock in on itself. That length of spare string you can see in the picture we’re going to tuck underneath the loop we make for the B string for a little extra snugness:

    tying knot on guitar string

    9. Don’t worry, you’ve done the difficult bit! There are a few ways to tie the strings on at the other end so I’ll show you how I do it. The string goes over the roller, underneath and up through the hole:

    securing guitar strings back into tuning pegs

    10. Now I’m going to pass it back through the hole, trapping the string in the loop:

    securing guitar strings back in tuning pegs

    11. Pull it back through the hole and it locks the string firmly in place:

    securing strings in tuning peg

    12. Next we just need to wind the string onto the tuner. I’ve left a bit of slack on the string which needs winding on and then we need to bring it up to pitch.
    Typically on classical guitars, the two E strings wind outwards and the other four inward to keep the break angle from as the string passes over the nut reasonably shallow. Here’s the E string winding its way:

    restringing classival guitar

    13. The bass strings are a little easier to tie on. If you have a square edge on the back of the tie block this single loop is enough to keep them anchored with the back of the loop over the edge of the tie block.
    (If the edge is worn and the string keeps sliding back you can tie them the same way as the trebles):

    tying bass string on base of guitar

    14. Here’s a view of the finished tie block. You can see clearly the loop used on the bass strings, and that each string is tucked into the loop of the next string along.
    I’ve trimmed the ends so that they’re not sticking out or trailing against the soundboard, which can be a cause of erroneous buzzing. It looks neat and should anchor the strings nice and strong:

    restrung strings viewing on body of guitar

    16. And here’s the finished headstock end, also trimmed nicely:
    It’s a little fiddlier than a steel string but give it a couple of goes and you’ll find you get the hang of it pretty quickly!


    finished restrung guitar viewing from neck of guitar

    forsyth logo

    Forsyth is a Take it away music shop member based in Manchester that offers an extensive Sales Departments for sheet music, classical and  jazz recordings, acoustic pianos, digital pianos, guitars, orchestral instruments and all accessories!
    They also have piano and instrument repair services with our own tuners, technicians and luthiers.
    Find out more and get in touch by visiting their website: www.forsyths.co.uk

    Tell us what you think @takeitawaymusic